30
English
4. Select 5.1 Speaker or 7.1 Speaker from the Speaker
Configuration pull-down menu.
5. Plug the front speaker cables into the Headphone-Out Jack.
6. Plug in the cables (you may require an adapter to connect each
cable to the appropriate jack e.g a stereo mini to dual RCA
adapter) from your speakers as follows:
• Line-In Jack = Side Speaker Out
• Microphone-In Jack = Center/Subwoofer Speaker Out
• S/PDIF-Out Jack = Rear Speaker Out (7.1 Speaker only)
7. As you plug in each cable a dialog box will pop up.
8. Click to put a tick in the appropriate box according to the
speaker plugged-in (e.g. Rear Speaker Out), and then click OK
to save the setting.
9. Click OK to exit Realtek HD Audio Manager.
Figure 30 - Connected Device Auto Popup
Sound Blaster Audio
Install the Sound Blaster application to allow you to
configure the audio settings to your requirements for the
best performance in games, music and movies.
Sound Blaster X-Fi MB5 AP Installation
1. Click Option Drivers (button).
2. Click 4.Install SBX-Fi MB 5 AP > Yes.
3. Choose the language you prefer and click Next.
4. Click Ye s to accept the license.
5. Click Next > Full Installation (button).
6. Click Next > Finish to restart the computer.
Sound Blaster X-Fi MB5 Application
Run the Sound Blaster control panel from the notification
area of the taskbar. Click on the tabs to access any of the
control panel menus. Note that the Sound Blaster audio ef-
fects do not apply to audio generated through an HDMI/
Mini DisplayPort connection.
Figure 29
Speaker Con-
figuration
Figure 31
Sound Blaster X-Fi
MB5
(Taskbar Notifica-
tion Area Icon)
P870DM CUG.book Page 30 Tuesday, November 24, 2015 1:40 PM
To Next Page
Loading...
