Clevo W270EGQ User Manual

Modules & Options
3G Module 7 - 35
7
Wireless Manager
With the 3G module and USIM card (supplied by your service provider) installed
you may then install the Wireless Manager application. The Wireless Manager
application allows you to directly access your HSPA internet service from the com-
puter.
Wireless Manager Installation
1. Enable power to the module by pressing the Fn + key combination (give
the module about 10 seconds to power on).
2. If a Found New Hardware window appears, click Cancel (click Cancel for
all Found New Hardware windows that appear).
3. Insert the Device Drivers & Utilities + User’s Manual disc into your DVD
drive.
4. Click Option Drivers (button).
5. Click 5.Install 3G Driver > Yes.
6. Click Next > Next > Install.
7. Click Finish.
8. Access the Wireless Manager application from the Start menu or the desk-
top shortcut .

Wireless Device
Operation Aboard
Aircraft
The use of any portable
electronic transmission de-
vices aboard aircraft is usu-
ally prohibited. Make sure
the module(s) are OFF if
you are using the computer
aboard aircraft.
Use the Fn + key com-
bination to toggle power to
the 3G module, and check
the indicator to see if the
module is powered on or
not (see Table , on page 1
- 12/ Table 1 - 3, on page 1
- 9).

Clevo W270EGQ Specifications

General

Memory Slots	2
Maximum Memory	16GB
Display Size	17.3 inches
Operating System	Windows 7 / 8
Optical Drive	DVD Super Multi
Wireless LAN	802.11 b/g/n
Bluetooth	Bluetooth 4.0
USB Ports	2 x USB 3.0, 2 x USB 2.0
Processor	Intel Core i7-3630QM
Storage	2.5" SATA HDD/SSD
Graphics Memory	2GB
Display Resolution	1920x1080 pixels
Weight	3.0 kg
Audio	High Definition Audio
LAN	10/100/1000 Mbps
Card Reader	Multi-in-1 card reader
Webcam	2.0MP
Battery	6-cell Lithium-Ion
Dimensions	413 x 277 mm