Clevo W370ET - Page 36

Disassembly
2 - 12 Removing and Installing the Processor
2.Disassembly
Processor Installation Procedure
1. Insert the CPU (Figure 8a), pay careful attention to the pin alignment, it will fit only one way (DO NOT FORCE
IT!), and turn the release latch towards the lock symbol (Figure 8b).
2. Insert the heat sink
at an angle of around 30° as indicated in Figure 8c.
3. Tighten the CPU heat sink screws in the order
, , , , , & (the order as indicated on the label
and Figure 8d).
4. Replace the component bay cover.
A
B
D
1
2
3
4
5
6
7
45°
b.
B
a.
D
Note:
Tighten the screws in the order
as indicated on the label.
A
c.
d.
2
1
3
4
6
5
7
Figure 8
Processor
Installation
a. Insert the CPU.
b. Turn the release latch to-
wards the lock symbol.
c. Insert the heat sink.
d. Tighten the screws.

A. CPU
D. Heat Sink
•7 Screws