Clevo X7200 - Removing the Keyboard

Disassembly
2 - 12 Removing the Keyboard
2.Disassembly
Removing the Keyboard
1. Turn off the computer and remove the battery (page 2 - 5).
2. Remove screws
- from the bottom of the computer (Figure 8a).
3. Turn the computer over, open the Lid/LCD, and carefully (a cable is connected to the underside of the LED cover
module) unsnap up the LED cover module from point on the right (Figure 8b).
4. Disconnect cable and remove the LED cover module (Figure 8c).
1
3
4

6. LED Cover Module
•3 Screws
5
6
Figure 8
Keyboard Removal
a. Remove screws from the
bottom of the computer.
b. Turn the computer over,
open the Lid/LCD, and
carefully (a cable is con-
nected to the underside of
the LED cover module) un-
snap up the LED cover
module from point on
the right .
c. Disconnect cable and re-
move the LED cover mo-
dule .
4
a.
b.
2
3
4
1
c.
5
5
6
6