Clevo X7200 - Removing the Hinges; Remove the LCD

Disassembly
2 - 26 Removing the Hinges
2.Disassembly
Removing the Hinges
1. The whole LCD assembly is detached from the base of the computer.
2. Re-insert hinges & (Figure 21a) into the top case and raise the LCD to a 90° angle (Figure 21b) to adjust
the positioning of the hinges for removal.
3. Remove the whole LCD assembly again from the base of the computer (Figure 21c).
4. Remove screws - at the base of the LCD assembly (Figure 21c).
Figure 21
Hinge Removal
a. Re-insert the hinges into
the top case.
b. Raise the LCD to a 90°
angle.
c. Remove the whole LCD
assembly again from the
base of the computer.
Remove the screws at
the base of the LCD as-
sembly.

1. LCD Assembly
•4 Screws
1
2
3
4
7
a.
2
3
4
5
6
b.
1
c.
Note:
This is the position of the hinges prior to
re-inserting them into the top case of the
computer.
Note:
This will be the new position of the hinges
after re-inserting them into the top case of
the computer.
7