Clevo X7200 - Page 128

Upgrading The Computer
6 - 12 Upgrading the Hard Disk Drive(s)
6
5. Remove screws - from the hard disk assembly.
6. Separate the HDD from the case .
7. Insert the replacement HDD into the case (make sure the cable connector is
facing towards the rear of the case as illustrated below).
8. Replace screws - .
9. Insert the HDD assembly into the bay by pushing it straight down (do not insert the
assembly at an angle) and then slide it in the direction of arrow to lock in place.
Figure 6 - 9
Secondary HDD
Assembly Removal
6
9
10
11
6
9
12
6
7
8
9
11
10
12