Clevo X7200 - Page 135

Upgrading The Computer
Upgrading the System Memory (RAM) 6 - 19
6
12. Gently pull the two release latches ( & ) on the sides of the memory
socket(s) in the direction indicated below.
13. The RAM module will pop-up, and you can remove it.
14. Pull the latches to release the second module if necessary.
15. Insert a new module holding it at about a 30° angle and fit the connectors firmly
into the memory socket.
16. The module’s pin alignment will allow it to only fit one way. Make sure the module
is seated as far into the socket as it will go. DO NOT FORCE the module; it should
fit without much pressure.
17. Press the module in and down towards the mainboard until the socket levers click
into place to secure the module.
18. Replace the shielding plate (see over) screws, keyboard (reconnect the keyboard
cable) and LED cover module (see the preceding pages).
Figure 6 - 20
RAM Module
Removal

Contact Warning
Be careful not to touch
the metal pins on the
module’s connecting
edge. Even the cleanest
hands have oils which
can attract particles, and
degrade the module’s
performance.
LED Module Cable
Make sure you recon-
nect the keyboard cable
( Figure 6 - 15). and
LED cover module cable
(see Figure 6 - 12).
11
4
19
20
21
19
20
21
19
20
19
20