CLF ARES - Static Color Options; Manual; Auto Show; Master;Slave

WWW.CLF-LIGHTING.COM
10.0
There are three options for Static color:
1. NO CALIBRATION
Color calibration mode is off.
2. MANUAL
Manual calibration mode, RGBW to white is according your custom calibration.
Manual calibration can calibrated by the control panel and DMX channel.
Calibrate by control panel
1. Press MODE button until MANUAL is displayed, press ENTER
2. Enter the password
3. Set【Red,Green,Blue】to white by custom calibration
Calibrate by DMX channel
channel 3 is set to 245-249 to enter dmx controller calibration
【 】
Channel
Function
Value
Setting
1
No function
000 255 -
2
No function
000 255 -
3
No function
000 255 -
4
Calibrate by
DMX channel
000 - 229
230 - 234
240 - 244
245 - 249
250 - 255
No function
come back to DMX mode
No function
turn on manual calibration mode by dmx control
Illuminate display
Value must be held for 3 seconds to activate.
5
Save
Correction
000 254
255
-
No function
Save Correction, Value must be held for 3 seconds to activate.
6
Red
000 - 255
0 - 100%
7
Green
000 - 255
0 - 100%
8
Blue
000 - 255
0 - 100%
9
White
000 - 255
0 - 100%
3. FACTORY
calibration mode
Fixture is calibrated in the factory by radiant machine.
Static Color options
Auto show
The auto function gives 20 automatically RGBW color combinations which are running without any DMX console.
Hit [ENTER] to adjust the speed of the program from 1-20
1) Auto 1
6) Auto 6
11) Auto 11
16) Auto 16
2) Auto 2
7) Auto 7
12) Auto 12
17) Auto 17
3) Auto 3
8) Auto 8
13) Auto 13
18) Auto 18
4) Auto 4
9) Auto 9
14) Auto 14
19) Auto 19
5) Auto 5
10) Auto 10
15) Auto 15
20) Auto 1-19 cycle
Master/Slave
You can choose between master or slave functioning. The chosen mode is visible in the homescreen. The fixture will
automatically go to slave function when no DMX signal is offered.