Need help?Do you have a question about the Clifford Concept 450 and is the answer not in the manual?
How to arm the system, including passive arming features.
Procedures for disarming the system without the primary transmitter.
How to silence and reset the system remotely when triggered.
Temporarily disable arm/disarm chirps for single operations.
Temporarily disable specific sensor inputs to the system.
Automatic sensor bypass for Intellistart and SmartWindows features.
Bypassing sensor inputs when auxiliary output is active.
Activating panic mode to attract attention and lock doors.
Procedures for disarming or entering Valet Mode using the PIN.
Temporarily bypass the auto-arming feature for a single cycle.
Notification for a low transmitter battery condition.
Recalling and displaying the last eight system triggers.
Interpreting system behavior during arming, including bypass notifications.
Interpreting system feedback during disarming, including tamper alerts.
A chart detailing system actions based on chirps and light flashes.
Setting up automatic (passive) or transmitter-based arming.
Configuring automatic door locking based on ignition or RPM.
Configuring automatic door unlocking when the ignition is turned off.
How doors lock during passive arming sequences.
Initial steps to access user-selectable features programming.
Navigating through programming feature columns.
Adding new remote controls to the system via autolearning.
Enabling or disabling the passive arming function.
Adjusting the volume or disabling arm/disarm chirps.
Configuring automatic door locking based on ignition or RPM.
Configuring automatic door unlocking when the ignition is turned off.
Controlling door locking during passive arming.
Setting the duration for alarm sounds and panic mode.
Enabling or disabling the second unlock output feature.
Enabling or disabling the False Alarm Control Technology feature.
Enabling or disabling valet mode operation via remote control.
Configuring the system's entry delay for passive arming.
Restoring all system settings to their original factory defaults.
Enabling or disabling the panic feature for immediate alert activation.
Configuring automatic start based on battery or temperature conditions.
Customizing a transmitter channel for arm/disarm functions only.
Programming a transmitter channel to activate accessory output A.
Programming a transmitter channel to activate accessory output B.
Arming/disarming the system without siren chirps.
Setting the system to enter or exit valet mode via transmitter.
Activating or shutting down the IntelliStart remote start system.
Activating window vent or roll down features with SmartWindows.
Erasing all programmed remote control codes from system memory.
Description of the audio sensor for detecting glass break sounds.
Description of the dual-zone shock sensor for impact detection.
To Next Page
General