Clifford Concept 650 User Manual

EAK216611
An executive agency of the Department for Transport
October Version 3
4171
THE UNITED KINGDOM VEHICLE APPROVAL AUTHORITY
COMMUNICATION CONCERNING THE APPROVAL GRANTED OF A TYPE
OF ELECTRICAL/ELECTRONIC SUB-ASSEMBLY
(1)
WITH REGARD TO
REGULATION NO: 10 AS AMENDED BY THE 02 SERIES OF
AMENDMENTS
Approval No: 10R-03548
7
1.
Make (trade name of manufacturer): Directed Electronics
2. Type and general commercial description(s): 350HV (426V), 426P Python 460HP 1 way,
Matrix +1 p/n 3105X, Matrix 1X p/n 3305X, 350 plus p/n 3105V, Responder 350 p/n 3305V,
3305P Python 460 two way and 3105P Python 460 max 1 way
3. Means of identification of type, if marked on the component
(1)
Sticker on base of unit
3.1 Location of that marking: On top of unit
4. Category of vehicle: Not applicable
5. Name and address of manufacturer:
Directed Electronics
1 Viper Way
Vista
CA 92081
United Sates of America
6. In the case of components and separate technical units, location and method of affixing of the
ECE approval mark: Printed on Sticker on top of unit
7. Address(es) of assembly plant(s):
Nutek
No.167, Lane 235
BauChiau Road
ShinDian City
Taipei County 231
Taiwan
U
K
A
p
p
r
o
v
a
l
A
u
t
h
o
r
i
t
y
24-Mar-10

Clifford Concept 650 Specifications

General

Range	Up to 1 mile
Engine Immobilizer	Yes
Door Lock Control	Yes
Trunk Release	Yes
Panic Mode	Yes
Valet Mode	Yes
System Type	2-Way
Remote Control	Yes
LCD Display	Yes
Shock Sensor	Yes
Battery Backup	Yes

Summary

TEST REPORT

6. Test Results

Summarizes the outcome of the tests performed, indicating compliance.

transmitter functions

Standard configuration

Describes default transmitter button assignments.

Expanded configuration

Details transmitter button assignments for the optional four-button transmitter.

using your system

active arming

Explains how to activate or arm the system using the transmitter.

passive arming

Describes the automatic arming feature and its countdown process.

multi-level security arming

disarming

Steps to disarm the system using the remote transmitter.

high security disarm

disarming without a transmitter

Procedure to disarm using ignition key and Valet button.

valet mode

diagnostics

arming diagnostics

disarming diagnostics

table of zones

code hopping

owner recognition

programming options

forced passive arming

Automatic Engine Disable (AED)

installation options

Vehicle Recovery System (VRS®)

PIN Programming

mux (multiplex) sensors

adjusting the 506T glass tamper sensor

adjusting and testing the 509U ultrasonic sensor

adjusting the 507C tilt/motion sensor

adjusting the proximity sensor

adjusting the omnisensor

auto-immobilisation feature

blackjax* feature

blackjax activation sequence

Describes how the BlackJax sequence is triggered and initiated.

troubleshooting

Starter kill issues

Checks for correct starter wire interruption and ignition input.

Sensor trigger issues

Suggests checking NPC system and retesting the shock sensor.

Door input issues

Valet switch & Status LED issues

wiring reference guide

control module

H1 harness

Details wire connections and functions for the 18-pin primary harness.

H2 harness

Explains wire connections and functions for the 8-pin secondary harness.