Clifford Concept 650 - Expanded Configuration; Standard Configuration

©
2008
Directed Electronics All rights reserved
23
5.
RReelleeaassee..
Once the code is learned, the Valet/Program switch can be released.
To exit the learn routine:
One long chirp indicates that Learn Routine has been exited. Learn Routine will be exited if any of
the following occurs:
➤➤
Ignition is turned off.
➤➤
Door is closed.
➤➤
Valet/Program switch is pressed too many times.
➤➤
More than 15 seconds elapse between steps.
Transmitter Configurations
The transmitters can be programmed with the standard or expanded configurations by using the
Auto Learn functions in the Transmitter/Receiver Learn Routine.
Standard Configuration
When programmed for standard configuration, the transmitter buttons are assigned to the
following functions:
operates Arm/Disarm
operates Channel 2 and Silent Mode
operates Panic
and operates Channel 3
Expanded Configuration
The expanded configuration features are available with the optional four-button transmitter only. A
remote that uses the expanded configuration operates similarly to many factory keyless entry
remotes. An expanded configuration transmitter allows arming, disarming, and Panic Mode
activation with separate buttons. When programmed for expanded configuration, the transmitter
buttons are assigned to the following functions:
N426P_2008-08.qxd 8/14/2008 10:40 AM Page 23
U
K
A
p
p
r
o
v
a
l
A
u
t
h
o
r
i
t
y
24-Mar-10