14
© 2001 directed electronics, inc.
The security system will ignore the input that was active when
the system was armed, until the input goes away. Three seconds
later the system will monitor that input normally. For example,
if your vehicle has interior light exit delay, and you arm the
system before the interior light goes out, you may hear Bypass
Notification chirps. Once the light shuts off, however, the doors
are monitored normally.
disarming diagnostics
Extra disarm chirps are the Tamper Alert. If four chirps are heard
when disarming, the system was triggered in your absence. If five
chirps are heard, a zone was triggered so many times that
False Alarm Control Technology (FACT) has bypassed that zone.
In either case, the LED status indicator will indicate which zone
was involved (see Table of Zones section). The system will retain
this information in its memory, and continue to chirp four or
five times each time it is disarmed, until the next time the igni-
tion key is turned on.
table of zones
The zone number is the number of LED flashes used by the
system to identify a specific input. The standard input assign-
ments are listed below, along with spaces to write in any optional
sensors or switches you have had installed.
➜
➜
To Next Page
Loading...
