© 2008 Directed Electronics- All rights reserved.
15
Optional Sensor Harness, 4-pin
Connector
The four-pin sensor harness is optional, and is not included with this unit.
RED (+) 12V Constant and BLACK (-) Ground:
These wires supply constant (+) 12 volts and ground to the optional sensor.
BLUE/GREEN (-) Multiplex Input:
These wires are multiplex inputs. If a (-) input of less than 0.8 seconds is
supplied to either wire, the Warn-Away response will occur. A (-) input of
longer than 0.8 seconds to either wire will initiate the triggered sequence and
report Zone 4.
To Next Page
Loading...
