INSTALLATION
Keep the wine cellar in vertical position 24H before setting up
Setting instructions
In order to get the most out of your wine cellar while keeping energy consumption to the lowest,
do not place your appliance near a heat source, in direct sunlight or in a room too cold. Optimal
performance is obtained at temperatures between + 16°C and + 32°C.
For the free standing hinge products and without front ventilation, a space of 70 mm must be left
between the wall and the rear of the appliance. This must be left unobstructed to allow air to
circulate otherwise the appliance will not work correctly. The appliance must be kept in a level
upright horizontal position to avoid possible vibrations or noises.
The air must circulate freely in front of the product.
Electrical connections
Your wine cellar is equipped with a mains lead and fitted with a 230V / 50Hz mono-phased plug,
in accordance with EC regulations / norms. The wall socket must be connected to the earth and
have a 10A minimum fuse protection.
Connect the appliance to the mains.
NOTE : The power (RUN) indicator light is located on the LED control panel inside the unit.
INSTALLATION OF SHELVES
STEEL SHELVES (depending models) :
1. Place shelves on grooves at height desired. See direction below :
Be sure to alternate shelve direction for proper bottle storage.
2. Insert the plastic stoppers (knobs) into the holes (pre-drilled) on both side of black liner.
17
To Next Page