Need help?Do you have a question about the CLIVET WSAN-XIN 25.2 and is the answer not in the manual?
General| Category | Heat Pump |
|---|---|
| Model | WSAN-XIN 25.2 |
| Cooling Capacity | 25.2 kW |
| Heating Capacity | 28.0 kW |
| Power Supply | 400 V / 3 Ph / 50 Hz |
| Refrigerant | R410A |
| Weight | 320 kg |
Procedures for handling unit failures and ensuring safety.
Requirements for user operational training on unit functions.
Procedures for safely handling and lifting the unit.
Criteria for selecting the installation location to ensure good operation.
Specifications for acceptable water quality to prevent issues.
Measures to prevent freezing of the unit or water connections.
Requirements for water flow rates to ensure proper operation.
Steps for making the hydraulic connections to the unit.
Procedures for system filling, washing, and testing.
Step-by-step guide for making electrical connections.
Procedures for connecting and configuring a PC to the unit.
Setup and cable requirements for Modbus communication.
Setup and cable requirements for LonWorks communication.
Setup and cable requirements for BACnet IP communication.
Essential checks to perform before initiating the unit startup.
Step-by-step procedure for starting up the unit.
Checks to be performed on the refrigeration system before startup.
Checks to be performed on the water circulation system.
Verification of electrical connections and phase balance.
Configuring the power demand limit using an external signal.
Adjusting temperature settings based on climatic conditions.
Configuring water reset parameters to affect setpoint.
Checking evaporator water flow-rate and pressure drops.
Procedures to change the unit's operating state (OFF, ECO, ON, Pump On).
Selecting the unit's operating mode (Cooling or Heating).
Overview of common potential risks related to electrical, handling, and refrigerant parts.
To Next Page