CLIVET WSAN-YSC4 - Alarm Management and Troubleshooting Guide

Keyboard settings
Step Action Menu - Variable Keys Display
1 Press 3 sec
2 Press
3 Select HMI Settings
4 Press
5 Press
6 Select Local connections
Allarms
Before resetting an alarm identify and remove its cause.
Repeated resets can cause irreversible damage.
Display of alarms: step 1-3
Reset alarm: step 4-10
Example: + eE001 Phase monitor: Fault = active alarm
- EE003 P1 failure: Ok = resetted alarm
Step Action Menu - Variable Keys Display
1 Press Alarm list detail
2 Press Alarm list
3 Select Alarm Alarm list detail
4 Press 3 sec Password
5 Set Enter password Alarm list detail
6 Press Alarm list
7 Select Alarm
8 Select Reset
9 Press 3 sec
10 Select Logoff
General list of alarms
The alarm code identifies the concerned circuit.
Example: ee101 TimeOutModCirc = circuit 1
ee201 TimeOutModCirc = circuit 2
Code Alarm type
ee, , ii Automac reset
eE, fF, iI Automac reset; aer N intervenon the alarm becomes manuale reset
EE, FF, II Manual reset
7 - CONTROL