FREQUENTLY ASKED QUESTIONS
What should I do if the following interface appears on TV?
Och, something wrong!
Don’t worry! ...
Don’t worry, it’s very easy to solve this problem. Please click the link below to find the answer.
https://www.cloner-alliance.com/help/knowledgebase/black_screen_tips_pro
Why is there a prompt “No signal”?
The default signal selection is HDMI. If you are trying to record from AV/VGA/YPbPr sources, please switch to the proper
input signal with the remote control or by pressing the “SOURCE”button on ClonerAlliance Box Pro.
If it still doesn’t work, please troubleshoot as below:
1. Please make sure the HDMI or AV/VGA/YPbPr source input is connected properly:
HDMI sources should be connected to the “IN”port (not the “MMI IN”or “HDMI OUT”port).
AV/VGA/YPbPr sources should be plugged into the “MMI IN”port (not the “IN”port).
43
To Next Page
Loading...
