14
mode those 8 buttons remain the same function as in the MASTER mode.
8. The DISPLAY: You will see all the VX
information here.
The digit buttons (NUMBER 0-9): They are used
to input values.
The SHIFT button: It is used with other control
parts for more functions.
The CURSOR/PAGE buttons: Use those buttons
to locate a place you want.
The DEC INC/ NO YES buttons: Use them to
change value or confirm an operation.
Important: In the U-CTRL mode, the Number
buttons, CURSOR/PAGE buttons and DEC
INC/NO YES buttons work in total different ways,
that is, they are used to control the DAW
software. Please refer to the related chapter for
more detail.
9. The DATA dial: Use it to change the value
quickly.
The EXIT/ENTER buttons: Use them to confirm
or cancel an operation.
Important: In the MASTER mode you will find
two useful shortcut buttons: SHIFT+EXIT is the
shortcut to send the reset message
SHIFT+ENTER is the shortcut to save all the
settings of the current BANK. However, you
cannot use the two shortcut buttons in the
U-CTRL mode.
Important: In the U-CTRL mode, the DATA dial
and the EXIT/ENTER button will have other
functions that they do in the MASTER mode. In
this mode, the buttons are used to control the
DAW software, and the DATA dial is used to
navigate to different song positions.
10. The U-CTRL button: Press it for the software
remote control mode, compatible with the Mackie
Control templates.
11. The encoder knobs (ENCODER 1-9): Those knobs have no start or end points,
and the functions can be user-defined.
Important: In the U-CTRL mode, the 9 knobs will have other functions than
they do in the MASTER mode. In this mode, they are used to control the Pan
settings (or other settings) of the current track BANK. Please refer to the
U-CTRL related chapter.
To Next Page
Loading...
Need help?
General
