38
• Fuels may be stored only for a limited
time. Never buy more fuel than you plan
on consuming within the next few
months.
Maintenance
• Before conducting any maintenance on
the device, always set the ignition switch
to[0] and pull the ignition cable plug.
• Check the fuel system regularly for leaks
or defective parts.
• Only those maintenance and fault elimi-
nation tasks described here may be car-
ried out. Any other tasks must be com-
pleted by a specialist.
• Only use original replacement parts. Only
these replacement parts are designed
and suitable for the device. Other
replacement parts will not only lead to an
invalidation of the warranty, they may
also endanger you and your environment.
Device-specific safety instructions
• Before starting work check the area and
remove all objects which may damage
the cutting mechanism.
• Always ensure sufficient distance to the
cutting mechanism.
• Only use unit at walking speed.
• Only work with good light and visibility.
• The clothing of the operator should be
close-fitting. Avoid wearing loosely fitting
clothing. Wear sturdy footwear and long
work trousers.
• Ensure that no other people or animals
are located in the area you are working in.
• When changing direction on a slope, be
particularly careful.
• Pay attention when walking backwards.
Danger of stumbling!
• Never place your hands or feet on or
under rotating parts.
• Exercise caution with tools that run-on.
Before commencing work on these tools,
wait until they have come to a complete
standstill!
• Pay attention to local regulations for rest
periods.
• Symbols affixed to your tools may not be
removed or covered. Information on the
device that is no longer legible must be
replaced immediately.
Personal protective clothing
Your device at a glance
►P.3, item1
1. Throttle
2. Handle
3. Handle, lower section
4. Motor
5. Ejection opening
6. Lever for adjusting the cutting height
7. Protective flap
8. Bag for cuttings
9. Pull starter holder
10. Clutch lever for travel drive
►P.3, item2
11. Pull starter
12. Motor oil filling screw
13. Ignition cable with spark plug
Observe the safety instructions be-
fore using the product for the first
time.
Read and observe the operating in-
structions before commissioning.
Highly flammable fuel! Danger of
fire!
Risk of injury due to flying objects!
Always ensure sufficient safety dis-
tance is held.
Touch parts only then when they
are completely stopped.
Never reach into the cutting mech-
anism.
Before any maintenance work, pull
out the ignition cable and read the
usage instructions.
Caution, hot surface! Danger of be-
ing burnt!
Petrol motors produce carbon
monoxide. Do not use indoors.
Wear ear defenders when working
with the device.
When working with the tool wear
sturdy footwear.
Wear goggles when working with
the device.
Wear safety gloves when working
with the device.
STOP
GB
Rasenmaeher_Benzin_468446.book Seite 38 Dienstag, 12. April 2016 9:49 09
To Next Page
Loading...
Need help?
General
