CMP PowerClean Salt Econ - CAUTIONS FOR EQUIPMENT DAMAGE OR PERSONAL INJURY

5
A. SAFETY INSTRUCTIONS & PRECAUTIONS
CAUTION – FAILURE TO HEED THE FOLLOWING COULD CAUSE DAMAGE TO POOL EQUIPMENT OR PERSONAL INJURY
• The Powerclean Salt Econ must be installed and operated as specied in the owner’s manual.
• Power to the Powerclean Salt Econ should be turned o before unplugging the Electrolytic cell from the cell housing, or
power supply, to prevent cell damage and low voltage sparks. Scratching or bending plates in the cell housing will reduce
cell life.
• DO NOT use any type of lubricant on the O-ring. It is, however, imperative that the O-ring (and the channel it seats into)
be kept clean, in order to make a strong seal.
• High water temperatures above 104 degrees (40 degrees C) or direct sunlight can cause the cell housing exterior plastic
to discolor. This is not a warranty claim.
• Follow installation instructions on page 7 for location and mounting of the Control Center.
• Visibly inspect the cell frequently to check and prevent the accumulation of pool
debris that (for any reason) may have bypassed the pool lter.
• Direct sunlight can cause the control center cover to discolor. This is not a warranty claim.
The Powerclean Salt Econ must be installed by a qualied pool professional or certied electrician. If you have any questions
or need assistance in nding a qualied installer, please contact our tech support team at 1-800-733-9060 or email
support@c-m-p.com.