Zero-3 / 5-Channel Motor Controller
CNC-STEP e.K. ▪ Siemensstrasse 13-15 ▪ 47608 Geldern ▪ Germany
Support: +49 (0)2831/91021-50
3.6 Safety devices
Emergency stop device with E-stop switches on the controller housing. (E-stop chain as
prescribed by applicable regulations)
3.7 Possible risks to people
Remaining hazard points
The safety equipment on the system is based on many years experience and conforms to
relevant regulations. Nonetheless, hazards arising from handling systems cannot be ruled out
completely.
Operating and service personnel need to be thoroughly familiar with remaining hazard
points and always carry out work on the system with appropriate attention to these in order
to avoid risks to life and limb of people or impairments of the machine and other real assets.
Safety equipment or safety measures are only fully effective if the machine is used as
specified. Particular caution is necessary in operating modes where safety equipment is
limited (setup, maintenance, repairs).
3.8 Duties of the system operator
System safety can only be achieved during regular operation if all measures required for
such safety are adopted. The operator of the system is responsible for planning these
measures and checking that they are carried out.
The system operator is required to maintain safety equipment on the system and in its
periphery in the condition they were in at the time it commenced operating.
The user must guarantee the cleanliness and neatness of the work space by means of
appropriate instructions and checks. In addition the operator should explain and teach
operating personnel safety conscious behavior by means of internal application-specific
rules and protective measures.
To Next Page
Loading...