CNC-Step Zero-3

To Next Page

To Previous Page

Operating Instructions

Zero-3 / 5-Channel Motor Controller

CNC-STEP e.K. ▪ Siemensstrasse 13-15 ▪ 47608 Geldern ▪ Germany

Page 4

Support: +49 (0)2831/91021-50

12.10.2012

5.1 Work in the interior of the housing ...................................................................................... 22

5.1.1 Opening the housing .......................................................................................................... 23

5.1.2 Changing fuses .................................................................................................................. 23

5.1.3 DIP switch settings ............................................................................................................ 24

5.1.4 Closing the housing ........................................................................................................... 24

6 TECHNICAL SPECIFICATIONS ................................................................................. 25

6.1 Absolute maximum ratings ................................................................................................... 25

6.2 Electrical connection values .................................................................................................. 25

6.3 Housing dimensions................................................................................................................ 26

7 CUSTOMER SERVICE ............................................................................................... 27

CNC-Step Zero-3 - Page 4