CNC4PC C25XP - Features

____________________________________________________________________________
___________________________________________________________________________
User’s Manual Page 1
1.0 FEATURES
• Connects directly to the motion controller or parallel ports
• Built-in PWM-Based Speed Control and Two Built-in Electromechanical
Relays with NO and NC positions for spindle control.
• The system monitors:
- E-Stop
- Safety Charge Pump.
• Electromechanical Relay with NO and NC positions for general purpose
(Port_2 16 or 17, jumper-selectable).
• Microcontroller based SCHP.
• Optoisolated inputs working at 5-24VDC.
• Can be powered with a voltage between +10 and +30VDC.
• Status LEDs on all input and Output connections.
• DIN Rail mountable.
• Open Collector Outputs pins 1, 14, 16, 17.
• Screw-On connections for all terminals.
• Status LEDs for enable.