____________________________________________________________________________
___________________________________________________________________________
User’s Manual Page 7
7.2 Configuration jumper mode US or INT
7.3 Configuration jumper pin 16 or 17
For the Variable speed control go to
http://cnc4pc.com/Tech_Docs/VARIABLE_SPEED_CONTROL.pdf
For Configure the control software go to
http://cnc4pc.com/Tech_Docs/CONFIGURATION_OF_CONTROL_SOFWARE.pdf
For Replacing Potentiometer go to
http://cnc4pc.com/Tech_Docs/Replacing%20a%20Potentiometer.pdf
To Next Page
Loading...