SHENZHEN CNCOTE TECHNOLOGY CO., LTD
Website: www.cncote.com Attn: Jack Foo,
Skype, cncote01, whatsapp, 008613480148499, email, jackfoo168@gmail.com
That shows installing completely.
8. Cautions of device wiring
8.1 Power code wiring:
The standard voltage is 9V-100V. Please use the power line which provided by the
manufacturer. The red line is the positive. The black line is the negative. The negative
should earth alone or link iron during installing. Do not connect it to other ground wire. And
please make sure the device is powered on status. (Power button on down position)
Red Led light will flashing while device installed correctly, GSM blue led light and GPS
Green led light will flashing around 1 minutes later after getting signal.
8.2, Usage of Device
Our GPS Tracker is used for motorcycle, electric-bike two wheels, electric-bike three
wheels. As well as for car ,truck etc four wheels vehicle.
9. Message commends
User can set different kinds of function commands via sending message, including check
position, cut engine, etc., below commands and punctuation marks must be putted under
English status. All commands will get auto replies according to the message sent.
Note device with initial password 6666
N
O. Features Commands
Replies from device
Remarks
1
Add administrator
No 1
#6666#AAD#
1#Cell No# ADD admin account 1 ok!
2
Add administrator
No 2
#6666#AAD#
2#Cell No# ADD admin account 2 ok!
For example：
#6666#AAD#1#15988888888#
Means administrator1 number is ：
15988888888，can add 2
administrator total
3
Delete
Administrator No 1
#6666#DAD#
1# Delete admin account 1 OK!
4
Delete
Administrator No 2
#6666#DAD#
2# Delete admin account 2 OK!
For example： #6666#DAD#1# for
delet the administrator
1 ;#6666#DAD#2# for delet the
administrator 2
5 Cut engine #6666#CF#
Fuel cut has already been
completed,OK!
For example：#6666#CF# ，only
apply for administrator
6 Restore engine #6666#OF#
Open fuel has already been
completed,OK!
For example：#6666#OF# ，Start
engine only apply for administrator.
7
Setting time
distance in moving
status
#6666#SMT#
sendconds#
Set movement upload
time,OK!
#6666#SMT#30# For example：
#6666#SMT#10#，Here the unit is
senconds 10 to 200s
To Next Page
Loading...