SHENZHEN CNCOTE TECHNOLOGY CO., LTD
Website: www.cncote.com Attn: Jack Foo,
Skype, cncote01, whatsapp, 008613480148499, email, jackfoo168@gmail.com
CS
PARAM#
View information STATUS#
Checking IMEI,IP，
Etc, Anybody
Re-start CQ Re-start the device Anybody
Vibration alarm specifications:
If you need vibration alarm, please follow below instructions:
1）Add admin number: please use your mobile phone to send a SMS to the device
according to the 1st command as above commands list(make sure to text the SMS under
English status). After add your number as administrator, device will reply you a SMS with
OK or failed.
2） Setting vibrate alert level: text a SMS to active vibration alarm and send to the
device(make sure to text the SMS under English status), and set the vibration alert level,
detailed please refer the 10th command as above commands list.
3）After finished above 2 steps, vibration alarm had been actived. As long as the car
stopped for more than 1minute, if somebody gets in touch with the car and didnt turn on
the ACC in 10seconds(ACC=0), the device will send SMS and call the administrator. If the
ACC was turned on in 10seconds, the device will judge it as the car owner himself and will
not alert the car owner. This is for not sending wrong vibration alert, active and close the
vibration alarm smartly.
Sleeping Mode with power saving Specifications:
The sleeping mode had been activated and defaulted inside the device in the factory：After
the car has switched off more than 5 minutes, the device will shut off all the led lights,
turn off GPS module and goes to sleeping mode to save the power of the vehicle’s battery.
There are 2 methods to exit the sleeping mode: 1)，Switch on the ACC，at this time , the
green ACC cable is high level up, this will lead device exit sleeping mode.。If ACC is
always on high level up,(means ACC is always on) the device will not goes to sleeping
mode. 2)，Shake the device to make it exit from sleeping mode.
During the first time testing, it is better to connect the ACC wire to high level up to locate
the GPS signal fast in the opening area as well as to avoid the device goes to sleeping
mode and could not locate the GPS after 5 minutes. (note: please do not test in room as
no GPS signal inside room). If client need to turn off the sleeping mode, please send SMS
to the device #6666#SLEEP#0# to close this function.
10.
Trouble shooting
10.1, After installing it in the first time, if device can not get connected with platform server,
at this time it is “logged off” status in platform. Please check the installation of device:
1) Check whether the connection of power-line is correct, please do not connect it with
the car control line.
To Next Page
Loading...