ITEM:2253K
ASSEMBLY INSTRUCTIONS
COASTER CO. SANTA FE SPRINGS,CA.90670
INSTRUCTIONS FOR BUNK BED MODEL # 2253K
SIZE OF MATTRESS
The length and width of the bunk mattress are as follow:
Length Width Thickness
Upper bunk 74" - 75" 37 1/2"- 38 1/2" 6" Maximum
Ensure thickness of mattress does not exceed 6” and there must be at least 5”
from mattress sleeping surface to top edge of guardrail.
SAFETY WARNING
1. Follow the information on the warnings appearing on the upper bunk end
structure and on the carton. Do not remove the warning label from bed.
2. Always use the recommended size mattress or mattress support or both to
help prevent the likelihood of entrapment or falls.
3. Surface of mattress must be at least 5 in. (127 mm) below the upper edge of
COASTERFURNITURE.COM
PAGE 5 OF 6
4. Do not allow children under 6 years of age to use the upper bunk.
5. Prohibit more than one person on upper bunk.
6. Periodically check and ensure that the guardrail, ladder, and other components
are in their proper position, free from damage, and that all connectors are tight.
7. Do not allow horseplay on or under the bed and prohibit jumping on the bed.
8. Always use the ladder for entering and leaving the upper bunk.
9. Do not use substitute parts. Contact the manufacturer or dealer for
replacement parts.
10. Use of a night light may provide added safety precaution for a child using
upper bunk.
11. Always use guardrails on both long sides of the upper bunk. If the bunk bed
will be placed next to the wall, the guardrail that runs the full length of the bed
should be placed against the wall to prevent entrapment between the bed and
wall.
12. The use of water or sleep flotation mattress is prohibited.
13. Keep these instructions for future reference.
STRANGULATION HAZARD:
14. Never attach or hang items to any part of the bunk bed that are not designed
for use with the bed for example, but not limited to hooks, belts, and jump ropes.
REPLACEMENT PARTS:
Replacement parts, including additional guardrails may be obtained from any
To Next Page
Loading...
