What to do if my Cobalt Digital Inc. Boat has performance loss?
If your Cobalt Digital Inc. Boat experiences performance loss, check that both throttles open fully at the engines. Ensure you're using the correct fuel. Reduce the load and distribute it evenly. Check for excessive water and drain the bilge if needed. Clean the hull if marine growth is present.
How to fix a Cobalt Digital Inc. Boat when the engine will not crank?
If your Cobalt Digital Inc. Boat's engine won't crank, ensure the lanyard is installed on the ignition safety switch and the battery switches are in the ON position. Check that the shift levers are in START or NEUTRAL. Verify the batteries are fully charged and the engine circuit breaker is in the operating position. Also, check and tighten the starter connections. If the solenoid clicks, check the battery connections.
What to do if there is no AC power in my Cobalt Digital Inc A28 BOWRIDER Boat?
If there's no AC power in your Cobalt Digital Inc. Boat, check if the circuit breakers are tripped or in the OFF position; reset the shore power inlet breaker or the breaker on the cabin distribution panel. Also, make sure the shore/generator selector switch is positioned correctly.
Why are the lights dim or not working on my Cobalt Digital Inc A28 BOWRIDER?
If the lights on your Cobalt Digital Inc. Boat are dim or not working, check if the circuit breaker is tripped or in the OFF position and turn it on. Also, check if the battery is discharged and charge it if necessary.
How to troubleshoot no water at the sink in my Cobalt Digital Inc A28 BOWRIDER Boat?
If there's no water at the sink in your Cobalt Digital Inc. Boat, check if the freshwater pump circuit breaker is tripped or in the OFF position and turn it on. Ensure the freshwater tank isn't empty and clean the filter located at the tank under mid-berth if it's plugged.
What should I do if an electrical component will not function on my Cobalt Digital Inc. Boat?
If an electrical component on your Cobalt Digital Inc. Boat won't function, check if the circuit breaker is tripped or in the OFF position. Correct the problem and reset the breaker, then turn it on.
What to do if the head will not flush on my Cobalt Digital Inc A28 BOWRIDER Boat?
If the head won't flush on your Cobalt Digital Inc. Boat, check if the head circuit breaker is tripped or in the OFF position, correct the problem, reset it, and turn the circuit breaker ON.
General| Brand | Cobalt Digital Inc |
|---|---|
| Model | A28 BOWRIDER |
| Category | Boat |
| Language | English |
Greeting and introduction to the owner's manual and Cobalt family.
Outlines the terms and conditions of the limited transferable warranty.
Explains the manual's purpose, intended use, and craft design categories.
Details owner responsibilities, warranty service, and transfer procedures.
Information on NMMA, MerCruiser, Volvo Penta certifications and construction details.
Explains the importance of legible warning labels and their locations for safety.
Provides definitions for common nautical terms used in boating.
Lists technical specifications and provides a layout diagram of boat components.
Outlines the responsibilities of the boat owner and operator for safety.
Details the minimum safety equipment required by the USCG and other standards.
Explains key boat systems like remote control, steering, fuel, and ventilation.
Lists essential checks to perform before starting the engines for safe boating.
Emphasizes operational checks, environmental responsibility, and regulatory compliance.
Covers fire safety, emergency preparedness, and component maintenance responsibilities.
Outlines navigation rules, sound signals, and right-of-way for safe boating.
Emphasizes caution for high-speed operation, visibility, and avoiding drugs/alcohol.
Stresses training, understanding controls, and preventing fire/explosion hazards.
Details safe fueling procedures and EPA fuel tank regulations.
Lists pre-launch checks, safe boarding, and proper loading for boat operation.
Covers pre-start checks, engine starting, and safe docking/mooring line techniques.
Explains trim adjustment, trim tabs, and safety for high-speed operation.
Guides on operating the glass cockpit dash unit and its various controls.
Details operation of marine toilets, macerators, and waste disposal systems.
Provides instructions for maintaining and operating bimini tops and other canvas covers.
Discusses mechanical, electronic, and manual operating systems for efficient use.
Illustrates the routing of fuel, water, and plumbing systems within the boat.
Details water system operation and the function of fire suppression equipment.
Explains the DC electrical system, circuit breakers, and fuses for proper function.
Emphasizes proper battery connections and the use of jump start receptacles.
Provides methods for cleaning vinyl and upholstery, avoiding sharp objects.
Explains Plynyl flooring properties and routine maintenance for longevity.
Provides a list of stain-removal procedures for common spills on flooring.
Guides on cleaning cabinetry, wood, carpet, and exterior fiberglass/gelcoat surfaces.
Advises on cleaning stainless steel monthly to prevent rust and pitting.
Provides information on maintaining Sunbrella canvas for appearance and operation.
Provides rules for maintaining the Awlgrip topcoat, including washing and stain removal.
Establishes a maintenance routine using the provided chart and component manuals.
A chart to help locate and resolve common engine problems.
Offers solutions for electrical and plumbing system malfunctions.
Emphasizes proper lifting techniques and preparing the boat for winter storage.
Provides a summary of key operational checks before launching and during operation.
Details procedures for starting engines, stopping, and returning to port safely.
Logbooks to record service history and fuel consumption for maintenance tracking.
Forms for creating a float plan and recording essential boat information.
A form to complete when transferring the boat's warranty to a new owner.
To Next Page