Cobb Accessport - Page 5

P. 4
Vehicle Identication:
The Accessport will attempt to automatically determine the target vehicle
for installation.
If the Accessport successfully identies the vehicle:
Verify that the identied vehicle is correct and press OK to conrm.
If an error occurs:
Please reference the Troubleshooting section of the Accessport User Manual for
additional information. The Accessport User Manual can be found online at
www.cobbtuning.com/subaru-ap
WARNING!
Do not disturb the Accessport or OBD-II cable while installation is taking
place. Failure to do so may result in incomplete ECU reprogramming
which will render the vehicle inoperable.
6. Make sure the clasp on the OBD-II cable rmly engages the tab on the
10 pin port. NOTE: Your Accessport may only have 9 pins. This is by design.
7. Turn the key to the ON position, turn o AC/heater fans and headlights,
and make sure all doors are shut.
NOTE: The engine
should not be running.
7. Select Install to proceed with installation.