Cobb Accessport - Map Selection

P. 5
Map Selection:
After the Accessport identies the vehicle, it will present a list of maps for
that vehicle. The map selected will become the base map for the vehicle.
To ensure the best performance, select the map that most closely matches
the modication level of the vehicle. Select a map and press OK to view
detailed information about that map. After conrming that the selected
map is correct, press OK again to proceed, or press CANCEL to return to the
map selection list.
Save Stock ECU Program Data:
After conrming the installation map, the Accessport will download the
current stock ECU program data from the vehicle. The Accessport saves
this data for use during the Uninstall process to ensure that the vehicle
is completely returned to stock. The download process will take a few
minutes to complete.
Install Accessport Programming:
With the stock ECU data saved, the Accessport will proceed with installation
to the vehicle. At this point the Accessport reprograms the vehicle’s ECU
with new program data and calibration parameters from the selected map
le. This process will take several minutes to complete.
Installation Complete:
The last installation process the Accessport goes though is clearing
trouble codes. When this step is complete turn o the ignition and wait for
approximately 10 seconds. After that is done your screen should now display
“Installation Complete”. You may now unplug the Accessport from the vehicle.
The Accessport does not need to be plugged in to the vehicle again until a
map change is necessary, however, it can remain plugged in to use the
Performance testing, Live Data monitoring and Data Logging features. Please
note that the Accessport is designed to work with only one vehicle at a time.
Once the Accessport is installed, it cannot be used with another vehicle until
it is uninstalled from the original vehicle.