Chapter 3: Operate the system
Use a phone or fax machine 39
3333
• Manual Dial. Dial 00 <country code> <phone number> followed by
# or off-hook key.
Example: To call Cobham SATCOM VA in USA that has the country
code 1 and the phone number 7574639557 press 00 1
7574639557 followed by # if calling from an analog or
ISDN phone.
If there was an error establishing the connection, refer to the
Troubleshooting Guide on page 99.
Dial timeout
1
When you place a call, the SBU needs a timeout after the last digit dialed
before the SBU can make the call. The timeout is approximately 5 seconds.
You can bypass this timeout by using the "#" key.
To answer a call.
To be able to receive a call, the phone must be connected to the relevant
interface of the SBU.
By default, all devices connected to the phone/fax interface, the ISDN
interface or the WLAN access point will ring when one of the mobile
numbers is called. Note, however, that this depends on the call type settings
made during initial configuration of the system. For further details on how
to set up the individual interfaces see the AVIATOR 200/300/350
Installation and maintenance manual and the documentation for your cabin
installation. You can see the current setting of the interfaces in the web
interface, see Access the web interface in the AVIATOR 200/300/350
system on page 28.
1. For 2-wire handsets and software version 4.00 or higher.
To Next Page
Loading...
