EasyManua.ls Logo

COBHAM SAILOR 800 XTR Ku - User Manual

COBHAM SAILOR 800 XTR Ku
191 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
SAILOR XTR Ku
Installation manual

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the COBHAM SAILOR 800 XTR Ku and is the answer not in the manual?

Summary

Installation Procedures

Installation: Site Considerations

Covers topics for installing the ADU, including general, obstructions, and radiation hazards.

Installation: ADU Installation Procedure

Describes the installation and grounding of the ADU, including safety precautions for lifting.

Installation: ADU (60 cm) Installation

Details the installation of the 60 cm ADU, including lifting harness and grounding.

Installation: BDU Installation and Grounding

Describes how to install and ground the BDU in a 19” rack.

Installation: Modem Installation

Covers mounting considerations for the VSAT modem and connection to the BDU.

Installation: 3 rd Party IP Device Integration

Explains how to integrate 3rd party devices within the antenna radome via interfaces.

Installation: Power and Startup Sequence

Details connecting power and the startup sequence for the SAILOR XTR Ku system.

Interfaces and Connectors

Interfaces: BDU Connector Panel Overview

Details the AC input connector and the ADU connector on the BDU.

Setup of the Antenna

Setup: Introduction to the Web Interface

Guides on using the built-in web interface of the BDU for system setup.

Setup: System Settings

Allows defining VSAT profiles, navigation input, blocking zones, and other settings.

Setup: Navigation Settings

Covers setting heading and position modes before calibration procedures.

Setup: Blocking Zones Configuration

Allows defining No TX/RX zones by entering azimuth and elevation angles for blocking zones.

Setup: Installation Wizard

Guides through necessary steps to set up the antenna, starting from the Settings section.

Service and Troubleshooting

Service: Built-in Test and LEDs

Explains the Built-In Test Equipment (BITE) function and BDU LEDs for fault diagnostics.

Service: Troubleshooting Basics

Provides initial checks for primary functions and guidelines for troubleshooting system faults.

Technical Specifications

Specifications: SAILOR 1000 XTR Ku ADU

Provides detailed technical specifications for the SAILOR 1000 XTR Ku Above Deck Unit.

Specifications: SAILOR XTR Ku BDU

Provides detailed technical specifications for the SAILOR XTR Ku Below Deck Unit.

Dual Antenna Solution

Dual Antenna: Configuration

Details configuring the Master and Slave BDU for dual antenna operation.

VSAT Modem Settings

VSAT Modem: Blockage Performance Optimization

Explains how to optimize performance in blockage situations with multiple satellites.

VSAT Modem: OpenAMIP Setup

Describes the OpenAMIP protocol and interface between BDU and VSAT modem.

Grounding and RF Protection

Grounding: Recommendations for BDU and ADU

Provides detailed recommendations for grounding the BDU and ADU to the ship's hull.

Event Messages

Event Messages: Overview

Explains how the system detects and reports events requiring action.

Event Messages: Detailed List

Provides a list of event IDs, modules, types, descriptions, and explanations for system events.

COBHAM SAILOR 800 XTR Ku Specifications

General IconGeneral
Antenna Diameter1.0 m
Reflector Size1.0 m
Operating Temperature-25°C to +55°C
Frequency Range (Tx)13.75 - 14.5 GHz
Frequency Range (Rx)10.7 - 12.75 GHz
Azimuth RangeUnlimited
Wind Operational20 m/s
HumidityUp to 100% condensing
Antenna TypeKu-band VSAT
TrackingAutomatic
Power Consumption100W (typical)
PolarizationLinear
Pointing Accuracy0.2°

Related product manuals