To Next PageTo Next Page
Need help?Do you have a question about the COBHAM Sea Tel Tracker 6000 and is the answer not in the manual?
General| Type | Marine Stabilized Antenna |
|---|---|
| Stabilization | 3-axis |
| Polarization | Linear |
| Wind Survivability | 100 knots |
| Compliance | FCC, CE |
| Antenna Diameter | 1.5 meter (59 inch) |
| Weight | 295 kg (650 lbs) |
Essential safety measures for operating and servicing the equipment, including PPE.
Caution regarding the internal lithium battery and its proper handling.
Guidelines for choosing an optimal installation site for the antenna.
Strategies to minimize signal degradation from obstructions and RF interference.
Instructions for preparing the mounting foundation, especially concrete pads.
Guidance on locating and installing equipment within the vessel's interior.
General guidelines for installing and routing cables, including protection and securing.
Detailed requirements for ADE/BDE coaxial cables, including loss and quality.
Guidance for antenna power, ACU power, and gyro compass cables.
Reference to installation chapter for grounding and bonding information.
Important warnings and torque specifications for assembly.
Steps to prepare for the installation process, including site and tools.
Preparing the ODU mounting location and unpacking components.
Detailed process for marking and drilling mounting holes for the pedestal and radome.
Instructions for opening and staging the general assembly crate.
Procedure for mounting the pedestal base section onto the concrete pad.
Steps to open the radome crates and stage the panels.
Detailed steps for assembling the bottom layer of the radome panels.
Instructions for assembling the top layer of the radome panels.
Procedure for assembling the third layer of the radome panels.
Steps for assembling the fourth layer of the radome panels.
Detailed instructions for assembling the pedestal sections and components.
Steps for assembling the antenna reflector hub and petals.
Procedure for installing the assembled reflector onto the antenna structure.
Steps to lower and secure the upper radome assembly.
Instructions for making power, ground, and signal connections into the ODU.
Guidance on installing the maintenance mode switch and door sensor.
Routing internal cables through the pedestal for power, coax, and sensor signals.
Steps for installing interior lighting fixtures and associated wiring.
Cautionary steps for removing service brackets after assembly is complete.
Procedures for performing final checks and clearing the installation area.
Reference to testing procedures and guidance on using system GUIs.
Safety precautions to be observed during maintenance activities.
Details on what is covered and not covered by the Sea Tel Limited Warranty.
Specifications for bolt tightening torques and Loctite usage.
Procedure for balancing the antenna using the "Balance Mode" feature.
Steps to install service brackets for immobilizing the antenna for service.
Cautionary steps for removing service brackets after maintenance is complete.
Detailed technical specifications for the Out Door Unit, including weight and pedestal.
Technical details for feed components and C-band radio package.
Specifications for receivers, noise density, and environmental operating conditions.
Technical details for various waveguide filters (Notch and Bandpass).
Specifications for the onboard GPS and additional waveguide filters.
Details on ICU connectors, coaxial switches, and status LEDs.
Specifications for integrated receivers, motor drivers, and ADE-BDE interfaces.
Technical details of the radome, lightning protection, and foundation mounting.
Compliance status for shock, vibration, safety, and environmental regulations.
