Sea Tel Tracker 6000 Maintenance
Systems. These equipments are covered by the applicable warranties of the respective
manufacturers.
Original installation of the system must be accomplished by, or under the supervision of, an
authorized Sea Tel dealer for the Sea Tel Limited Warranty to be valid and in force.
Should technical assistance be required to repair your system, the first contact should be to the
agent/dealer you purchased the equipment from.
Please refer to the complete warranty information included with your system.
5.3.
Torque and Loctite Specifications
WARNING: Assure that all nut and bolt assemblies are tightened according t o
the tightening torque values listed below:
SAE Bolt Size Inch Pounds Metric Bolt Size Kg-cm
1/4-20 75
M6
75.3
5/l6-18
132 M8
150
3/8-16
236
M10 270
1/2-13
517
M12 430
NOTE: Al l nu t s a nd b ol t s sh o ul d be as s e m bl e d u si n g t h e ap pr op r ia te Lo ctite
th r ea d - lo c ke r pro d uc t nu m b er f or t h e th r ea d si z e o f t h e h a rdw a re.
Loctite # Description
222 Low strength for small fasteners.
242 Medium strength
638 High strength for Motor Shafts & Sprockets.
2760 Permanent strength for up to 1” diameter fasteners.
290 Wicking, High strength for fasteners which are already
assembled.
5.4.
Balancing the Antenna
The elevation and cross-level motors have a brake mechanism built into them, therefore,
power
must be ON to release the brakes and DishScan®
and antenna drive
must be OFF to balance the
antenna. .
Do NOT remove any of the drive belts
. Balancing is accomplished by adding or
removing balance trim weights at strategic locations to keep the antenna from falling
forward/backward or side to side. The antenna system is not pendulous so 'balanced' is defined as
the antenna remaining at rest when left in any position.
The “Balance Mode” selection located on the upper part of the “Four Quadrant Test” screen in
the Tools – Test menu page. When enabled, Balance Mode temporarily turns DishScan®, Azimuth,
Elevation and Cross-Level drive OFF. This function is required when trying to balance this antenna
system.
Assure that Antenna power is ON and that the antenna has completed initialization.
At the Computer:
1. Log into the GUI, select Tools - Test in the side bar menus.
2. Select “Balance Mode” to enable balance mode. The screen will then show ON & OFF
buttons.
3. Click ON. The screen will temporarily display “Submitting … Please Wait”. When this
message disappears the antenna is in balance mode. DO NOT EXIT THIS SCREEN.
5‐2
EAR Controlled - ECCN EAR99
To Next Page