Need help?Do you have a question about the COBHAM SAILOR 900 and is the answer not in the manual?
General| Weight | 55 kg (121 lbs) |
|---|---|
| Polarization | Circular |
| Operating Temperature | -25°C to +55°C (-13°F to +131°F) |
| VSWR | 1.3:1 |
| Pointing Accuracy | 0.2° RMS |
| Ship Motion | ±15° roll, ±10° pitch |
| Survival Temperature | -40°C to +70°C |
| Axial Ratio | < 1.5 dB |
| Azimuth Coverage | Unlimited |
| Wind Survival | 200 km/h |
| Wind Operational | 100 km/h |
Outlines general safety precautions that all personnel must follow.
Details safety precautions regarding radiation hazards during operation.
Discusses potential sources of interference and mitigation strategies.
Provides step-by-step instructions for installing the Above Deck Unit (ADU).
Provides step-by-step instructions for installing the Antenna Control Unit (ACU).
Details the procedure for powering up the system.
Provides detailed steps for calibrating the antenna system.
Explains the procedure for performing azimuth calibration.
Guides on creating a service profile for calibration purposes.
Details the procedure for performing cable calibration.
Presents a flowchart illustrating the user-controlled calibration process.
Explains how to fine-tune TX polarization using the line up procedure.
Details configuration tasks using the system's web interface.
Guides on creating and managing modem and satellite profiles.
Explains how to define blocking zones for RX and TX.
Provides instructions for configuring the Local Area Network settings.
Details how to configure e-mail settings for reports.
Covers configuration for diagnostic reports, syslog, and SNMP traps.
Details the procedure for uploading new software to the system.
Covers administrative settings for system management.
Provides a checklist for verifying antenna installation.
Checklist for verifying ACU, connectors, and wiring.
Checklist for performing functional tests in harbor.
Provides information on how to obtain support via the Helpdesk.
Details the procedure for updating the system software.
Explains how system status is indicated via LEDs and messages.
Provides guidance and steps for troubleshooting system issues.
Details the OpenAMIP setup for iDirect modems.
Provides serial setup instructions for iDirect modems.
Covers protocols and configuration for COMTECH 570L and ROSS box.
Details protocols and interfaces for the COMTECH 570L modem.
Covers interfaces and configuration for STM SatLink 2900 modem.
Covers interfaces and configuration for Gilat SkyEdge II modem.
Covers interfaces and configuration for Inmarsat G5 modem.
Covers protocols, interfaces, and configuration for Linkway S2 modem.
Lists and describes the supported command line interface commands.
Provides recommendations for proper grounding of the system.
To Next Page