COBHAM SAILOR 900 - ACU Configuration; C.6.2 ACU Configuration

STM SatLink 2900 VSAT modem
C-24 Appendix C: VMU settings 98-150471-A02
Example:
odu antctrl show
Antenna Controller Configuration
--------------------------------
Type : Thrane & Thrane SAILOR 00
Enabled : All
IP address : 10.110.2.226
Polling frequency : 5 sec
Antenna Stability Tries : 300
Antenna Controller Status
--------------------------------
Controller detected : no
Packets sent : 0
Packets received : 0
C.6.2 ACU configuration
To set up the ACU to work with an STM Satlink 2900 VSAT modem, do as follows:
1. Add a modem profile with the STM Satlink 2900 modem. See Modem profiles on
page 6-23.
2. Add a satellite profile using the STM Satlink modem profile just created. See Satellite
profiles on page 6-26.
3. Edit the network settings and input the IP information supplied with the modem. See To
configure the LAN network on page 6-30.
4. Activate the satellite profile.
save config This will save the above settings to flash in
the modem. And restart the modem:
restart
Command Description
Table C-8: Configuration of the STM SatLink 2900 VSAT modem (Continued)
SAILOR900HP.book Page 24 Monday, July 18, 2016 12:44 PM