COBHAM SAILOR 900 - D.2.1 config

Supported commands
98-150471-A02 Appendix D: Command line interface D-3
Command line interface
D.2.1 config
D.2.2 demo
D.2.3 dual_antenna
D.2.4 exit
Command Description
config
Shows the sub commands available, including a short
description.
config pending_list
Shows the number of pending changes.
config current_list
Shows the values for the current satellite profile, antenna
and some tracking information.
config discard
Discards all pending changes.
config activate
Use this command to save and activate the pending
changes in the SAILOR VSAT system.
Table D-2: UCLI command: config
Command Description
demo start
Starts a demo pattern where the antenna will turn azimuth,
elevation and cross elevation until it receives the command demo
stop.
demo stop
Stops the antenna demo pattern.
demo reset
Resets the antenna to angle 0.
Table D-3: UCLI command: demo
Command Description
dual_antenna mode
Shows the current dual antenna mode
•single
•master
•slave
dual_antenna status
• Shows the current dual-antenna mode status
•active
•inactive
Table D-4: UCLI command: dual_antenna
Command Description
exit
Exits the connection to the SAILOR VSAT system.
Table D-5: UCLI command: exit
SAILOR900HP.book Page 3 Monday, July 18, 2016 12:44 PM