STM SatLink 2900 VSAT modem
98-150471-A02 Appendix C: VMU settings C-23
Modem configuration requirements
Type the following command in a modem console to set up the STM Satlink 2900 modem
to use the SAILOR 900 VSAT High Power:
Command Description
odu antctrl waitstablize 300 This configures the antenna stability tries
which is the amount of times the modem
should try to logon before it tries the next
beam in its transponder list.
odu antctrl periodictime 5 This configures the polling frequency in
seconds between the modem and ACU.
odu antctrl port 0 (zero) This configures the IP communication port
to default (5990). Use the command odu
antenna to configure the modem with
either SAILOR 800 VSAT or SAILOR 900
VSAT
odu antenna 30 This configures the antenna type to a
Thrane & Thrane / Cobham SATCOM
antenna.
NOTE: odu antenna 52 is supported
from modem software 16.0.0 or higher. Use
the command odu txtype to set the
BUC for either SAILOR 800 VSAT or SAILOR
900 VSAT.
odu txtype 62 This configures the BUC type to a SAILOR
VSAT BUC
NOTE: odu txtype 63 is supported
from modem software 16.0.0 or higher. Use
the command odu lnb to set the LNB for
either SAILOR 800 VSAT or SAILOR 900
VSAT.
odu lnb 62 This configures the LNB type to SAILOR
VSAT LNB
NOTE: lnb 63 is supported from modem
software 16.0.0. or higher.
odu antctrl enable all This will enable the communication
between the modem and ACU including
GPS input.
dvb rx autostart on This will enable modem rx.
dvb tx autostart on This will enable modem tx.
Save the new ODU Configuration:
Table C-8: Configuration of the STM SatLink 2900 VSAT modem
SAILOR900HP.book Page 23 Monday, July 18, 2016 12:44 PM
To Next Page
Loading...
