COBHAM SAILOR 900 - Status; Table D-9: UCLI Command: Status; D.2.8 Status

Supported commands
98-150471-A02 Appendix D: Command line interface D-7
Command line interface
D.2.8 status
satellite tx_rf_freq
satellite tx_rf_freq
14.123456
Shows or sets the RF frequency used for tx.
•Valid range:
Ku band: 13.75 GHz to 14.5 GHz.
Ka band: 29 GHz to 30 GHz.
Note: Configuring the Ku-band tx frequency
automatically configures the L-band frequency:
L-band frequency = Ku-band tx frequency – 12.8
GHz (BUC Lo)
Example: 1308.300000 MHz = 14.108300 GHz
– 12.8 GHz
satellite tx_if_freq
satellite tx_if_freq
1200.123
Shows or sets the IF frequency for tx.
•Valid range:
Ku band: 950 MHz to 1700 MHz.
Ka band: 950 MHz to 1950 MHz
Note: Configuring the L-band tx frequency
automatically configures the Ku-band frequency:
Ku-band frequency = 12.8 GHz (BUC Lo) + L-band
frequency
Example: 14.108300 GHz = 12.8 GHz +
1308.300000 MHz
a. Relevant for Ku band.
Command Description
Table D-8: UCLI command: satellite (Continued)
Command Description
status
Shows the sub commands available, including a short
description.
status system
Shows the current status of the SAILOR 900 VSAT High
Power.
status track_all
Shows the current values for all tracking parameters:
•vessel heading
•azimuth relative
• elevation relative
• polarisation skew
• GPS latitude and longitude
status event_list
Shows a list of active events.
Table D-9: UCLI command: status
SAILOR900HP.book Page 7 Monday, July 18, 2016 12:44 PM