Settings and Detection
Your Detector
Nothing Comes Close to a Cobra
®
15
Detection
The tables on the following pages show you the types of Signals your detector
will detect, as well as the voice and visual alerts it provides for each of them.
In Voice Alert mode you will first hear several tones, then a voice message
announcing the type of signal detected, followed by more tones. In Tone Alert
mode, you will hear the tones only.
In both Voice Alert and Tone Alert modes, a distinctly different alert tone is
used for each type of signal detected (including separate tones for each laser
signal). For X, K, Ka and Ku band radar signals, the tones will repeat faster as
you approach the signal source. The repeat rate of the tones gives you useful
information about the signal detected. (See responding to alerts on page 18.)
An indication of the type of signal detected will appear in the UltraBright
data Display. During X, K, Ka and Ku alerts, a number will also appear,
indicating the strength of the signal detected. (1 = weakest, 5 = strongest)
X Signal Detected
X K Ka V S 2
X K Ka V S 3 X K Ka V S 5 X K Ka V S 4
K Signal Detected Ka Signal Detected
Ku Signal Detected
To Turn Pop Alert On and Off
While no signal is
being detected,
press and hold both
the Dim and City
buttons for four
seconds.
Tone Voice
Visual Display
Pop On = Two beeps
Pop On
P will blink twice
in the display
Pop Off
P will blink once
in the display
Pop Off = One beep
Pop Alert (continued)
To Next Page
Loading...
