Cobra 25 NW ST - Receiving Signals; How to Receive

Setting Dynamike
This controls the microphone sensitivity
(outgoing audio level).
1918
Setting
Dynamike
Operation Operation
1
Initially, set fully clockwise so that maxi-
mum voice volume is available.Dynamike
may have to be reduced in some conditions.
Transmit
Push and hold mic button to transmit.
Transmitter is now activated.When transmit-
ting,hold the microphone two inches from
your mouth and speak in a clear, normal voice.
Release to receive.
1
Transmit
RF Meter
RF Meter
This meter swings proportionately to the RF
output (outgoing signal) while transmitting.
25 NWST Manual3.3 6/15/99 12:43 PM Page 18