8 | P a g e
CDR895D INSTALLATION
MOUNT
CAM 1 - Screw the suction cup into the Quick
Release Mount. Slide the mount into CAM 1
and press the lever to secure the unit to your
vehicle’s front windshield.
CAM 2 – Attach CAM 2 to the windshield using the adhesive
tape. CAM 2 is most commonly installed facing out the rear on
the top center of the rear windshield. It can also be mounted
on the front windshield to record the interior of the vehicle.
POWER
The CDR895D utilizes a Y-Splitter and CAM 2 Extender Cable to
offer maximum flexibility and clean installation without dangling wires.
Plug the Y-Splitter into the Micro USB Port on CAM 1.
Connect the Micro USB end of the power cord into the Y-Splitter. Connect the USB end
of the power cord in the Cigarette Lighter Adapter and then plug into your vehicle.
Plug CAM 2 into the Y-Splitter. Use the included CAM 2 Extender Cable if necessary.
Organize and tuck away cables to make sure that the driver’s view is not obstructed. In
most vehicles it’s possible to tuck Y-Splitter and cables into the headliner and cleanly
hide the extender cable along the top wall all the way to the rear of the vehicle.
Professional installation is recommended.
If CAM 2 videos appear upside-down enter the Video Settings Menu on CAM 1 and turn Flip
Cam 2 to ON.
If you have mounted CAM 2 facing forward enter the Video Settings Menu on CAM 1 and turn
Mirror CAM 2 to OFF.
To Next Page
Loading...
Need help?
General
