4
Cobra Connex ICD31
2 driver cards are supplied with the system.
The driver card should always be carried separately from the car keys
e.g. in your pocket, wallet or purse.
Cobra Connex recognises you as the authorised driver by detecting
your unique driver card when you are within approximately 1 - 5 meters
from your car. The ADR LED will blink when the driver card is out of
range and goes off when the driver card is detected.
If your vehicle is driven without the driver card, vehicle tracking and
recovery procedure is started automatically. You will receive a theft
alert on your mobile phone followed by a call from the SOC – and if
theft is conrmed, the SOC will initiate stolen vehicle recovery (SVR)
procedure on your car i.e. liaising with the police and continuously
updating it’s location for them to recover and return your car to you as
quickly as possible.
Driver card
The driver card has to be switched on for it to work. To switch on, briey
press the button on the driver card until the LED starts to blink.
To switch the driver card off to conserve the battery – for example if it
is to be stored and not used, press and hold the driver card button for
around 8 seconds until the LED goes off.
Automatic Driver Recognition (ADR) overview
As many as 4 driver cards can be used with the system at any one
time. If additional driver card is required, contact any Cycle and Carriage
Bintang Dealer.
To reduce the risk of car theft, lost driver card should immediately be reported
to Connex Customer Service where the lost card will be excluded from the
system. You will need to purchase a new driver card to replace the lost one.
i
Important
If the car is driven with the ADR LED still blinking, vehicle tracking and
recovery procedure is automatically started and you will receive an SMS
theft alert followed by a call from the SOC.
WARNING
The driver card should not be left in the car as this will compromise the ADR
protection function. In case of valet parking or servicing at a service dealer,
keep the driver card with you.
i
Important
WARNING
!
Never leave the driver card in the car.
The driver card should always be carried with you. If it is left in the car,
the ADR function is compromised and in case of a theft by stealing or
duplicating your car keys, the system will not be able to generate theft
alerts.
Driving the car
With your unique driver card with you, the ADR LED should be off
when you turn or press the ignition on to start the car. If the ADR LED
is still blinking, this means your driver card has not been detected by
the system.
The detection of your driver card should happen within approximately
1-5 meters of you approaching the car. If it is still blinking, briey press
the button on the driver card to manually switch the ADR LED off before
starting the car.
To turn OFF, press the button on the
card for at least 8 seconds or until
the LED is off
LED on the card is
not blinking
Turn ON by pressing the
button on the card once
LED