Turn on your MicroTalk 3 2-way radio.
An audible “tone” will indicate the unit is on.
The LCD will go through a 3 second self test
and then to operational mode.
Note
Both the calling and receiv-
ing units must be on same
channel and subchannel for
the call function to work.
Note
Your incoming “Call” audio
ringing level is dependent on
your unit’s volume s e t t i n g.
Operation
11
Operation
10
Select desired channel by pushing and
releasing buttons.
3
4
Wait for the party’s response or proceed to
“Talking To Another Party”section on next
page.
5
1
Calling
Another
Party
Calling Another Party
To alert another party that you wish to
communicate:
Channel
CallPush and release button.The indicator
icon will flash and the icon will remain on
for 3 seconds.The unit you are calling will hear
a 2 second ring tone.
Place antenna in full
upright position.
2
FRS300.MANUAL.qx 10/2/98 12:39 PM Page 16
To Next Page
Loading...
