PTT
...
Channel
Channel
Advanced Features
29
Advanced Features
28
Note
The MicroTalk 3 “zeros out”
the subchannels to allow
scanning of the main
channels.
Scan Function
Scan Function
Rotate ON - OFF Volume Control clockwise.
An audible “tone”will indicate the unit is on
and then the LCD will go through a 3 second
self-test and then go to operational mode.
2
1
Push and release buttons and the unit
will begin scanning the main channels.
Unit will continue to scan all main channels
and stop,if an incoming transmission is
detected.
3
4
Your MicroTalk 3 will pick it up for 10 seconds.
Within 10 seconds you can:
Push and hold button and talk. Your
radio will return to operational mode on
that channel.
or...
Push and release button to rescan the
main channel.
or...
Proceed to subchannel scan on next page.
A
B
C
continued
FunctionPush and release button until SCAN icon
and main channel flashes.
FRS300.MANUAL.qx 10/2/98 12:39 PM Page 34
To Next Page
Loading...
Need help?
General
