Cobra microTALK PR 900 DX - Basic Operation and Settings; Turning On and Display Illumination; Channel and Privacy Code Selection

5
Operation
Select
Channels
Note
Units must be on same Main
Channel and CTCSS Privacy
Code to communicate.
Note
Push and hold Channel Up
or Down Buttons for fast
channel/code advance.
Select Channels (1-15)
Main Channels 1-7 are shared with FRS radios.
Turn on your microTALK PR 900 DX.An audible
“tone”will indicate the unit is on and the LCD
will self-test for 2 seconds and then go to
Operational Mode.
Select channel by pressing and releasing the
ChannelUp or Down Buttons.
PRESS
UP OR DOWN
Select CTCSS Privacy Code (00-38)
Selecting a CTCSS Privacy Code will enable you
to filter out unwanted conversations and allow
greater privacy.For example,when with a group
of friends, you select channel 7 and privacy
code 1, you will hear your friends and filter out
conversations on channel 7 with privacy codes
2 through 38.
Select CTCSS
Privacy Code
Note
If you push and hold the
Mode Button,the LCD
display will cycle through
the different functions.
4
Operation
Illuminating
the Display
Illuminating the Display
Press and release Monitor Button to illuminate
display for ten seconds.
PRESS AND
RELEASE
Note
Wh e n e ver the unit is on yo u
can re ce i ve co m m u n i ca t i o n s,
( except while pushing the
P TT Talk Bu t to n ,or while
in Mode Fu n ct i o n ) .
Turning On
Your microTA L K
PR 900 DX
Turning On Your microTALK PR 900 DX
Turn the Volume Control clockwise to switch
power on.Set volume to desired level.Turn
the Volume Co nt rol co u nte r - c l oc kwise to turn
power off.
TURN KNOB
CLOCKWISE