11
If “oF” flashes in place of the privacy code numbers,
a privacy code is already set in the opposite (CTCSS
or DCS) system. Press the Channel Up or Channel Down
button to cancel the opposite code and select a privacy
code from the active system for the selected channel.
8. Choose one of the following:
a. Press the MEM/ESC button to enter the channel/privacy code
in the selected memory location. Radio then proceeds to next
memory location, which will blink.
b. Press the MEM/ESC button to save the current state of the Set
Memory Function, then press and hold the MEM/ESC button until
return to Standby mode.
To recall a stored memory channel location:
1. Press the MEM/ESC button, the Memory icon
and the memory location number show on the
display.
2. Press the Channel Up or Channel Down button
to select a memory location (0 through 9).
If a location has been programmed before,
its associated channel/privacy code will be
shown on the display.
3. Press the MEM/ESC button to return to
Standby mode on the selected memory
location.
M
E
M
E
S
C
M
a
x
R
a
n
g
e
H
I
/
L
O
W
To Next Page
Loading...
Need help?
General
