R. Tool retainer
Labels
The machine is fitted with labels containing important
information about personal safety and machine
maintenance. The labels shall be in such condition
that they are easy to read. New labels can be ordered
from the spare parts list.
Data plate
A. Machine type
B. Serial number
C. The warning symbol together with the book
symbol means that the user must read the
Safety and operating instructions before the
machine is used for the first time.
D. The CE symbol means that the machine is
EC-approved. See the EC Declaration of
Conformity which is delivered with the machine
for more information.
Noise level label
The label indicates the guaranteed noise level
corresponding to EC-directive 2000/14/EC. See
"Technical data" for accurate noise level.
Warning label
To reduce the risk of injury, everyone using,
installing, repairing, maintaining, changing
accessories on, or working near this tool must read
and understand the safety instructions before
performing any such task.
Operate with chisel retainer in place.
Emission compliance label
Emissions compliance period referred to on the label
indicates the number of operating hours for which
the engine has been shown to meet Federal
emissions requirements.
Category C = 50 hours, B = 125 hours, and A = 300
hours.
13© 2010 Atlas Copco Construction Tools AB | No. 9800 0995 93 | 2010-01-12
Original instructions
Safety and operating instructionsCOBRA PRO, TT, TT-AWD
To Next Page
Loading...
Need help?
General