4. DISASSEMBLING AND SERVICING
Wear gloves and eye protection during disassembly,
and take care not to allow the return spring to come out.
Installation Instruction
① Pass the recoil starter rope through the rope in the recoil
starter pulley and make a figure-eight knot at the rope end.
install it.
Check the rope foe wearing and broken before reassembling, then,
② Hang the side hook of the recoil starter spring in the
groove of the recoil starter case, set the recoil starter
spring into the case with counterclockwise rotating
starter spring.
CUTOUT
REEL COVER GROOVE
③ Set the recoil starter spring outside hook into the groove
of the recoil starter pulley.
④ Set the starter drive cam on the recoil starter pulley, and
install the return spring on the recoil starter pulley while
hooking it on the side of the driving cam.
⑤ Install the spring, drive guide and fixing screw in order and
tighten to the specified torque.
Screw torque value：10±2 N·M
To Next Page
Loading...