Cobra Y173V - Page 35

33
4. DISASSEMBLING AND SERVICING
4-4-5 Governor
Removal / Installation
BOLT M6×12
GOVERNOR SHAFT HOLDER
PLATE
PIN φ 9×14
PIN φ8×14
CRANKCASE COVER
WASHER φ6.5×φ12×1
GOVERNOR DRIVEN GEAR:
Before Installing , Check For Wear
WASHER
φ6.5×φ15×0.5
GOVERNOR SLIDER:
Insert the governor
slider into the governor
shaft and check for
slider moving smoothly
GOVERNOR HOLDER
SHAFT(Alight the shaft
groove with the
projection in case)